Tetraeder Toolset

Tetraeder Creation Toolset These 2 "Tools" are all YOU need to create 70.5° Tetraeder's ANYWHERE! (4 sided "Pyramids" build from ONLY Triangles) - Just build a Triangle at whatever Size you want(up to around ~50,then you reach the max Height limit in ARK) - Use a small Wall (to guarantee snap Direction), glue the 70.5° Flipper to it & build the one Foundation, that has the "Floor" facing outward - Add some Triangle Ceilings to that Foundation & catch the Angle with a (thin)Pillar !!![make sure there is NOTHING above the Pillar on placing & it doesnt touch the Foundation, or you might end up with a "not-Foundation" Pillar]!!! - Add a (thin)Beam to the 70.5° Ceiling to glue the Floor & the Angle together (Pillars placed on the 70.5° Angle will be "invisible" and give you a smooth outer Wall without Bumps!) - Do that for all 3 Sides(or the 6 Corner Sides) and you got a Tetraeder! To add Floors use the "Tetraeder Floor-Creator" (up to 25 Floors Height... was limited by the Hammers reach!) - Choose any Side & add an Foundation "L" (or whatever) you need a "north-turned" Snappoint, so just add a small Pillar Beam to a Foundation & that will give you the "forward/North-turned Snap" ...the more distance you give this, the easier it is for the hammer to actually find the right snap... (see Screen) - Place normal Pillars on the Scaffolding until you reach the desired Height & add a small Wall, that will allow you to place Ceilings "Inside" - Use thin Pillars on the 70.5° Sides as Glue to hold the Floors (i would glue them into the Corners, but up to YOU ofc!) - Remove all Scaffolding Fill/close them however YOU like, just know, since its ONLY Triangle Ceilings, the Numbers add up QUICK! To close the Gap between the Ground and the Floor, you can snap ramps to the 70.5° and use "Triangle-Roof-Corners" to close this perfectly (like its made for This) I have one standing around my Well on Ragnarok for over a year now & its just n0ice, i think! Enjoy building YOUR own 70,5° Tetraeder's!