The Twin-Repli Crafting Oval

描述

This places a small Foundation Oval +16 offset above a normal Floor and adds two half Circles of Dedi's [26], with the Twin-Replicators centered inside the Oval - You can snap this to any existing Foundation Grid, no matter the Height [up to ~3/4 of a wall high] As long as you have a 9x6 Hole in your Foundations & a "North-turned" snap-Point. - If its placed too low for the 90°Foundations, the 2 Failsafe Pillars will create the two 90° Ceilings! so no worries - The Foundations inside the Oval are only Suggestions [at the right height]. if you want to fill it "standalone", use the Triangles on the Outside, otherwise, just "cut" normal Ceilings trough the entire Oval's Foundations, as well as over the 90°ones. - to close this, fill the Dedi half Circles to "3-stacks", then close the Ovals walls & finish it with a rim of quarter Ceilings ontop & you have a standalone Crafting Oval! for the Dedi-Plate Version(wich goes up to 126 dedis): - make sure its placed 5 Steps High and i guarantee you, all will build Flawlessly! - if its too low, the Failsafe Pillars will kick in & build the 90° parts for you, but then you will have to pick up the Cellar-Doors, build Ceilings & Dedis in the Center & then replace the Cellar Doors, on the 90°Beams! (Dedis can not be placed after the Cellar-Doors!) enjoy