mho

24 Dedi Circle

this places 24 dedi's around a 12(24small) sided triangle circle

48 Dedi Circle

this places 48 dedi's around a central pillar (on the outside of a 24(48small) sided triangle circle)

48 sided House +Floors +Roof

48Sided House with Floors & Roof - its the 48 sided small foundation circle with large walls all around - the upper rim is a layer of quarter walls, that are needed to offset the triangle roofs & also have the pillars in them to make it all "one ring" [if you want to make the foundation ring "one" , you need to add pillars on the foundations] - the entire center is just one of the four 12 sided circle plates lowered by 16 & i gave it connection to the outer rim on 3 sides with 8 offset [meaning you can freely overlap these floors & have ceilings cut into foundations] - to close the floors, fill the outer rim with triangles & then the leftover 90°gaps with quarter ceilings - lastly use quarter ceilings all around(on the large walls) to cover up your floor plates pointy ends & id recommend also adding a ring of pillar-beams! it gives it an overall solid look you can have any one wall/pillar going up to hold the floors/ceiling, i just used 3 pillars for symmetry & safety^^ - the triangle roofs would block the ramps "below them" from being build, so these have to be added by hand later on to close the roof - as final touch add a ring of railing onto the ceiling plate on top (its a great spot for a teleporter for example) - the 3 "gates" are made out of 4 tek ceiling doors, held by that pillar frame i think thats all enjoy

96 ,48, 24 Foundation Rings

this builds the largest possible circle the hammer allows! (if we try to pick this up anywhere else, then the central pillar, the opposite side is out of reach) a full 96 sided ~30.5 diameter circle (including the 48 and 24 sided rings) PS: i will upload more circles & rings later on!, this just has em all in one

45° Foundation Flipper

This places four 45° foundations around a central pillar (wich is the roof angle, but ceilings are shorter then roofs, keep that in mind!) the foundations are turned clockwise & flipped "nose down" enjoy

Foundation Flipper

this places four 90° Foundation around a central Pillar the foundations are turned clockwise & then flipped "nose down" if this is glued to a 90° Foundation, it will give us normal back & even upside-down! (wich means, this tool lets us freely flip back & forth, perfectly aligned!) all these angles can be interconnected & held up with pillars & beams, at any angle! enjoy

Foundation Stacker Up+Down

place this onto any foundation or pillar & it will create offsets that allow us to stack ceiling & foundations - the +/-8 offsets can connect to the starting height & the +/-16 offset can overlap ceilings! PS: this can also make dedi plates & stack fridges & co, by adding a quarter ramp to the +/-16 offset!, its all you need! this is my first template here so, enjoy