ItsA_Envy

Compact Triple Stack Vault

Follow the pictures attached. Step 1: - Setup you floor for the vaults. it needs to be 1 Quarter wall lower than walking floor level - Place Quarter ceiling in the back or the hole you left for the vaults to fall into Step 2: - Place and build '1st and 2nd Layer' template and break thatch wall Step 3: - Place '3rd row Final Final' template and break thatch wall Note: You can not place all three layers at the same time. the 3rd row will fall into the first row and you ill have to pick them back up Note: Both templates ate fully auto buildable provided it is not obstructed I added a normal 1 layer template in as well.

No Stuck - 7x7 Cryo Floor With Snap

Follow the Pictures attached. Step 1: - Build the foundation where your cryos are going to be on. - This could be either Foundation, Ceiling, Vacuums - Make sure there is a wall in the bottom left corner so that the template can snap to it (Otherwise it wont line up) Step 2: - Snap the template and Autobuild. (It will finish building on its own unless its obstructed) Step 3: - Finish the build of by placing ceilings around the cryos to make it flush with floor

Turret Tower

Basic Turret Tower without Anti Stego roof Mostly auto buildable only part of the internal anti-Racer will need to be manually built. (Its like 20 door frames). The second template are the turrets you place the foundi in the center part of the tower. It will line up