Modèles de construction

Turtle boat

Embark on an expedition to the open sea in a turtle-shaped boat! It can be attached to rafts and motorboats.

AX Ring Foundation

this is not a full build rather a foundation to build your own ideas on this a ring foundation 12 tiles in diameter

TH_PILLAR_SIDEWAYS

sideways pillar that is used it my builds

Pillar 1

No description available

カジノ

わるちゃん

AVENGERS

Enjoy

test4

test4

JP-styled Raptor Pen (OG Aaron Longstaff design)

Taken inspiration from Aaron Longstaff's second take on the titular Raptor pen seen in Jurassic Park (1993). This pen can be used to house 4-6 Raptors or Deinonychus. This is my first public template and I hope you all enjoy it. Some structures may be missing and this was built on Official - future builts will be built on single player. NOTE* Skins are not included in this build.

Maze Pack 2

Create your own maze with these maze templates. included pieces: Room piece and Room with Entrance/Exit door. Best way to connect them is to add 1 foundation on the piece you want to extend and snap on that foundation for a smooth connection. other maze pieces are in Pack 1

Maze Pack 1

Create your own maze with these maze templates. included pieces: Straight piece, Corner piece, T piece, Cross piece and End piece. Best way to connect them is to add 1 foundation on the piece you want to extend and snap on that foundation for a smooth connection. Room not included. these are in Pack 2

Steep Wall Setup

The snap of this template is for aligning the 90 degree flipped foundations with normal structures. Both flipped orientations are included so both directions of steep walls are possible. You can remove the flipped foundations after placing, normal pillars will provide support once placed. build along the flipped beams/pillars to position the walls where you want, then ensure normal pillars' snaps are intersecting the flipped beams/pillars snaps, then you can remove everything but the beams used for snapping the sloped walls, as normal structures like ceilings/walls/etc will support the sloped wall after placement.

Leuchtturm

No description available